Dell PowerVault 122T DLT VS80 (Autoloader) Uživatelský manuál stáhnout pdf (Strana 14)

12 Dell PowerVault DLT, VS, and SDLT Media Handbook Version 2.0

www.dell.com | support.dell.com

Cartridge Inspection

•

Case:

Inspect the case for cracks, chips, or signs of damage.

•

Cartridge:

Inspect the exterior of the cartridge for chips, cracks, dents, or missing screws.

Gently shake the cartridge. Listen for rattling or loose pieces.

•

Cartridge Door:

Ensure that the door is moveable and that the spring is present.

•

Write Protect Switch:

Move the switch. It should snap into write-protected mode and write-

enabled mode.

•

Cartridge Leader:

Gently inspect the cartridge leader to verify that it has not been damaged

and is in the correct position.

•

DLTtape Cartridges

: Check the height of the leader to ensure that the loop is sticking up

approximately 3/16 inch or 4 mm. Ensure that the door operates. DLT tape leader loop

should be visible and undamaged.

•

Super DLTtape Cartridges

: Check that the Super DLTtape leader buckle aligns with

cartridge edge and metal pin is not bent.

NOTE: When inspecting the cartridge leader do not use anything that could leave contamination,

such as a pen or pencil.

Figure 1-18. DLTtape Leader Loop

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

Dell PowerVault 122T DLT VS80 (Autoloader) Uživatelský manuál Strana 14