Dell Serial Attached SCSI Host Bus Adapter 5i Integrate Uživatelský manuál stáhnout pdf (Strana 15)

Hardware Installation 13

Hardware Installation

This chapter describes how to install the Dell™ Serial-Attached SCSI (SAS) 5/E Adapter.

NOTE: See your system’s Hardware Owner’s Manual for instructions on installing the SAS 5/i Integrated.

Installing the SAS 5/E Adapter

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of

the components inside the system. Authorized service technicians: Before performing any procedure, see

your Product Information Guide for complete information about safety precautions, working inside the

computer, and protecting against electrostatic discharge.

Unpack the SAS 5/E Adapter and check for damage.

NOTE: See "Getting Help" on page 35 if the adapter is damaged.

Turn off the system and attached peripherals, and disconnect the system from the electrical

outlet. See your system’s

Hardware Owner’s Manual

for more information on power supplies.

Disconnect the system from the network and remove the cover of the system. See your system’s

Hardware Owner’s Manual

for more information on opening the system.

Select an appropriate

PCI-E slot. Remove the blank filler bracket on the back of the system

aligned with the PCI-E slot you have selected.

NOTE: The SAS 5/E Adapter must be placed in the expansion slot and the SAS 5/i Integrated adapter

must be placed in the embedded slot. See your system documentation for more information about the

PCI-E slots.

Align the SAS 5/E Adapter to the PCI-E

slot you have selected.

Insert the adapter gently, but firmly, until the adapter is firmly seated in the PCI-E slot.

See Figure 3-1.

KD534bk1.book Page 13 Monday, April 2, 2007 4:37 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Žádné komentáře

Dell Serial Attached SCSI Host Bus Adapter 5i Integrate Uživatelský manuál Strana 15