Dell Dimension XPS T___ Uživatelský manuál stáhnout pdf (Strana 19)

5.25-Inch Drive

To remove the 5.25-inch drive, perform the following steps:

1. Remove the bezel.

2. Remove the drive cage.

3. Remove the three drive-mounting screws, and slide the drive out of the drive bay.

When you replace a drive, set the jumpers on the replacement drive to match the jumpers on the drive you removed. For additional information

about jumper settings on EIDE drives, see EIDE Subsystem.

Primary Hard-Disk Drive

To remove the primary hard-disk drive, perform the following steps:

1. Remove the bezel.

2. Remove the two drive-assembly mounting screws.

3. Lift the primary hard-disk drive out of the card guide assembly.

4. Disconnect the DC power and interface cables from the back of the drive.

To reinstall the primary hard-disk drive, place the drive's circuit board toward the front of the chassis.

When you replace a hard-disk drive, set the jumpers on the replacement drive to match the jumpers on the drive you removed. For additional

information about jumper settings on EIDE drives, see EIDE Subsystem.

Drive-mounting screws (3)

Primary hard-disk drive

Card guide assembly

Drive-assembly mounting screws (2)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 52 53

Žádné komentáře

Dell Dimension XPS T___ Uživatelský manuál Strana 19