Dell OptiPlex GX1p Uživatelský manuál stáhnout pdf (Strana 129)

Removing and Replacing Parts on the Mini Tower Chassis 6-13

To remove a 5.25-inch drive assembly from the middle or lower drive bay, fol-

low these steps:

1. Disconnect the DC power cable and the interface cable from the back of

the drive.

2. Press in on the two retaining tabs (one on each side of the drive), and slide

the drive assembly forward to remove it.

3. Remove the four screws attaching the 5.25-inch drive to the mounting

plate, and lift the drive out of the mounting plate (see Figure 6-12).

When you replace the 5.25-inch drive, align the front of the drive flush with the

tab at the front of the mounting plate. Insert the four screws, and tighten them

in the order stamped on the bottom of the 5.25-inch drive-mounting plate.

Align the front of the drive

flush with the tab at the

front of the 5.25-inch

drive-mounting plate.

screws (4)

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 169 170

Žádné komentáře

Dell OptiPlex GX1p Uživatelský manuál Strana 129