Dell OptiPlex NX1 Uživatelský manuál stáhnout pdf (Strana 153)

Removing and Replacing Parts on the OptiPlex NX1 Net PC Chassis 7-11

5LVHU%RDUG

To remove the riser board, follow these steps:

1. Remove the expansion-card cage.

2. Remove the expansion card if one is installed.

3. Lay the expansion-card cage on a flat work surface, with the riser board

facing up.

4. Remove the riser-board mounting screw.

5. Slide the riser board to the side as shown in Figure 7-10, and then remove

the riser board from the expansion-card cage.

When you replace the riser board, be sure that the two tabs on the expansion-

card cage engage the riser board slots.

riser board

riser-board

mounting screw

expansion-card

cage

tabs (2)

slots (2)

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 169 170

Žádné komentáře

Dell OptiPlex NX1 Uživatelský manuál Strana 153