Dell Precision 220 Uživatelský manuál stáhnout pdf (Strana 18)

Back to Contents Page

CD-ROM,Tape,DVD,andZipDrives:DellPrecision™WorkStation220SystemUser's

Guide

Installing a CD-ROM, Tape, DVD, or Zip Drive in a Mini Tower Chassis

This section describes how to install an enhanced integrated drive electronics (EIDE) CD-ROM, tape, Digital Versatile Disc (DVD), or Zip drive.

For small computer system interface (SCSI) drives, see "Installing SCSI Devices."

To install a CD-ROM, tape, DVD, or Zip drive in the mini tower chassis, perform the following steps.

1. Unpack the drive and prepare it for installation.

NOTICE: Ground yourself by touching an unpainted metal surface on the back of the computer.

Check the documentation that accompanied the drive to verify that the drive is configured for your computer system. Change any

settings necessary for your configuration.

2. For an EIDE drive, configure the drive for the Cable Select setting as described in the documentation that accompanied your drive.

3. Remove the computer cover as instructed in "Removing and Replacing the Computer Cover. "

4. Remove the front panel as instructed in "Removing and Replacing the Front Panel."

5. Remove the drive bracket from the bay you want to use.

Squeeze the metal tabs that extend from each side of the drive bracket toward each other, and pull the bracket out of the bay (see Figure 1).

Figure 1. Removing a Drive From the Mini Tower Chassis

If a drive is already installed in the bay and you are replacing it, disconnect the DC power cable and interface cable from the back of

the drive before sliding the bracket out of the bay. To remove the old drive from the bracket, turn the drive/bracket assembly upside

down and unscrew the four screws that secure the drive to the bracket (see Figure 2).

6. Attach the drive bracket to the new drive.

Turn the drive upside down, and locate the four screw holes around its perimeter. Fit the bracket over the drive so that the screw holes align.

To ensure proper installation, all screw holes should be aligned and the tabs on the front of the bracket should be flush with the front of the

drive (see Figure 2).

Figure 2. Attaching the Drive Bracket to the New Drive

Installing a CD-ROM, Tape, DVD, or Zip Drive in a Mini Tower

Chassis

Installing a CD-ROM, Tape, DVD, or Zip Drive in a Desktop

Chassis

CAUTION: Before you remove the computer cover, see "Safety First—For You and Your Computer."

NOTE: For easier access inside the chassis, you may want to rotate the power supply out of the way temporarily. To do so, see

"Rotating the Power Supply Away From the System Board."

Bracket tabs (2)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 99 100

Žádné komentáře

Dell Precision 220 Uživatelský manuál Strana 18