Dell S320wi Uživatelská příručka stáhnout pdf (Strana 41)

2 Left This button acts like the left click button of a

mouse.

3 Function Functions available are listed in the OSD Menu

"Set function" (see page 70).

NOTE: Double-clicking the Function button

will act as Undo, if supported by the

software.

4 Mini USB charge

connector

Allow you use Mini USB cable to charge. See

"Charging the Interactive Pen Battery" on page

44.

5 LED indicators Two LED indicators are available: Green and

Amber (see "Interactive Pen LED Guiding

Signals" on page 133).

6 Right This button acts like the right-click button of a

mouse.

7 Power switch Turns the Interactive Pen on or off.

8 Firmware upgrade

connector

For Interactive Pen and RF board firmware

upgrade.

OSD warning messages - low battery

• The Low Battery warning message pops up when the battery voltage is

lower than 2 V. At this condition, the pen can still work about 1~2 hours.

• The pen will be disabled when the battery voltage is lower than 1.8 V.

Combinations of buttons

• Left + Function: The Pen Information menu appears on the screen.

• Hold Function: Hold the Function button for 2 seconds and the

Function mean will appear on the screen. Use Left/Right to move

up/down and use Function to enter/apply.

• When Toggle is selected in the Set Function menu, press the Function

button to select Normal/Draw/Stable mode.

NOTE: Interactive pen cannot support Windows Mouse property function

"Switch primary and secondary buttons".

Using Your Projector 41

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 151 152

Žádné komentáře

Dell S320wi Uživatelská příručka Strana 41