Dell MD3200i Uživatelský manuál Strana 203

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 272
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 202
Management: Installing Array Components 203
Hard Drives
SAFETY: Models AMT, E03J, and E04J
Models AMT, E03J, and E04J are intended for installation only in restricted
access locations as defined in cl 1.2.7.3 of IEC 60950-1:2005.
Depending on your configuration, your array either supports up to twenty
four 2.5" SAS hard drives or up to twelve 3.5" SAS hard drives in internal drive
bays. Hard drives are connected to a backplane through hard-drive carriers
and can be configured as hot-swappable.
Removing a Hard-Drive Blank
CAUTION: To maintain proper system cooling, all empty hard-drive bays must
have drive blanks installed.
1
If installed, remove the front bezel
. See
"Removing the Front Bezel" on
page 202.
2 Press the release tab and
slide the hard-drive blank out until it is free of
the drive bay.
See
Figure 15-2 for PowerVault MD3200 and Figure 15-3 for
PowerVault MD3220.
Figure 15-2. Removing and Installing a 3.5" Hard-Drive Blank (MD3200 Only)
1 hard-drive blank 2 release tab
1 2
book.book Page 203 Tuesday, June 18, 2013 2:53 PM
Zobrazit stránku 202
1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 271 272

Komentáře k této Příručce

Žádné komentáře