Dell 5460 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Notebooky Dell 5460. DELL Vostro 5460 Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 39
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Dell Vostro 5460
Owner's Manual
Regulatory Model: P41G
Regulatory Type: P41G001
Zobrazit stránku 0
1 2 3 4 5 6 ... 38 39

Shrnutí obsahu

Strany 1 - Owner's Manual

Dell Vostro 5460Owner's ManualRegulatory Model: P41GRegulatory Type: P41G001

Strany 2 - Notes, Cautions, and Warnings

4. Release the tabs that secure the battery in the battery bay.5. Lift and remove the battery from the computer.10

Strany 3 - Contents

Installing the Battery1. Place the battery into its slot until it clicks into place.2. Connect the battery cable to its connector on the system board.

Strany 4

b) base cover3. Follow the procedures in After Working Inside Your Computer.Removing the Coin-Cell Battery1. Follow the procedures in Before Working I

Strany 5 - Working on Your Computer

Installing the Wireless Local Area Network (WLAN) Card1. Insert the WLAN card into its connector at a 45–degree angle.2. Tighten the screw to secure t

Strany 6 - Turning Off Your Computer

5. Lift and remove the left system fan from the computer.6. Disconnect the right system fan cable from its connector on the system board.7. Peel away

Strany 7 - System Overview

Installing the Heat Sink1. Place the heat sink into its original position on the system board.2. Tighten the screws that secure the heat sink to the s

Strany 8 - Removing the Base Cover

Installing the Memory1. Insert the memory module into the memory socket.2. Press the memory module down until it clicks into place.3. Install:a) heat

Strany 9 - Removing the Battery

4. Remove the screws that secure the system board to the chassis.5. Remove the system board from the computer.17

Strany 10

Installing the System Board1. Place the system board into its original position on the chassis.2. Install the screws that secure the system board to t

Strany 11 - Removing the Hard Disk Drive

4. Lift the speaker assembly along with the routing cable in the direction indicated and remove the speakers from the computer.19

Strany 12

Notes, Cautions, and WarningsNOTE: A NOTE indicates important information that helps you make better use of your computer.CAUTION: A CAUTION indicates

Strany 13 - Removing the System Fan

Installing the Speakers1. Place the speakers into its original position on the computer.2. Route the speaker cable along the routing channel.3. Connec

Strany 14 - Removing the Heat Sink

4. Remove the screws that secure the display hinges to the system board.5. Lift and move the system base panel away from the display hinges to facilit

Strany 15 - Removing the Memory

Installing the Display Assembly1. Align the base panel of the computer to the display hinges.2. Install the screws that secure the display hinges to t

Strany 16 - Removing the System Board

5. Remove the screws that secure the screws to the display bezel.6. Pry along the inner edges of the display bezel and remove the display bezel.23

Strany 17

Installing the Display Bezel1. Align the display bezel by pressing along the edges.2. Install the screws that secure the display bezel.3. Install the

Strany 18 - Removing the Speakers

4. Lift and remove the display from the back panel.25

Strany 19

Installing the Display1. Align the display to the base panel by pressing along the edges.2. Install the screws that secure the display.3. Install :a)

Strany 20 - Removing the Display Assembly

3System SetupSystem Setup OverviewSystem Setup allows you to:• change the system configuration information after you add, change, or remove any hardwa

Strany 21

NOTE: For most of the system setup options, changes that you make are recorded but do not take effect until you restart the system.Table 1. Navigation

Strany 22 - Removing the Display Bezel

System Setup OptionsMainTable 2. MainSystem Time Re-sets the time on the computer's internal clock.System Date Re-sets the date on the computer&a

Strany 23

ContentsNotes, Cautions, and Warnings...21 Working on

Strany 24 - Removing the Display

SATA Operation Change the SATA controller mode to either ATA or AHCI.Default: AHCIFunction Key Behavior Specifies the behavior of the function key <

Strany 25

4TroubleshootingEnhanced Pre-Boot System Assessment (ePSA) DiagnosticsThe ePSA diagnostics (also known as system diagnostics) performs a complete chec

Strany 26 - Installing the Camera

Battery Charge LED Off/Hibernate StandbyDischarging when Battery charge is <=10%Off Blinking WhiteDevice Status LightsTurns on when you turn on the

Strany 27 - System Setup

5SpecificationsTechnical SpecificationNOTE: Offerings may vary by region. For more information regarding the configuration of your computer, click Sta

Strany 28 - Updating the BIOS

Feature DescriptionStereo conversion 2.1Speakers 3Volume controls Function Keys (F6–F8)Table 11. VideoFeature DescriptionVideo type UMA/DISVideo Contr

Strany 29 - System Setup Options

Table 15. DisplayFeature DescriptionType HDDimensions:Height 205.6 mm (8.09 inches)Width 320.9 mm (12.63 inches)Diagonal 14.0"Active area (X/Y) 3

Strany 30 - Table 5. Boot

Feature DescriptionCharge time 3 hourVoltage 11.4 VTemperature range:Operating 0 ℃ to 50 ℃Non-Operating 0 ℃ to 65 ℃Coin-cell battery LI 3V 83 MAHTable

Strany 31 - Troubleshooting

Feature DescriptionStorage 20% – 95%Altitude (maximum):Operating–15.2 m to 3048 m (–50 to 10,000 ft)0° to 35°CNon-Operating –15.2 m to 10,668 m (–50

Strany 33 - Specifications

6Contacting DellContacting DellNOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, pack

Strany 34 - Table 13. Communication

Installing the Display...

Strany 35 - Table 18. Battery

1Working on Your ComputerBefore Working Inside Your ComputerUse the following safety guidelines to help protect your computer from potential damage an

Strany 36 - Table 21. Environmental

CAUTION: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the c

Strany 37

2Removing and Installing ComponentsThis section provides detailed information on how to remove or install the components from your computer.Recommende

Strany 38

3. heat sink4. system fan5. mSATA solid state drive card6. WLAN card7. coin-cell battery8. speaker9. battery10. hard drive11. speakerRemoving the Base

Strany 39 - Contacting Dell

Installing the Base Cover1. Place the base cover to align with the screw holes on the computer.2. Tighten the screws to secure the base cover to the c

Komentáře k této Příručce

Žádné komentáře