Dell 5560 Uživatelský manuál

Dell Vostro 5560Owner's ManualRegulatory Model: P34FRegulatory Type: P34F001

Installing the Base Cover1. Place the base cover to align with the screw holes on the computer.2. Tighten the screw to secures the base cover to the c

Installing the Battery1. Slide the battery into its slot until it clicks into place.2. Connect the battery cable to its connector on the system board.

7. Remove the screws that secure the hard-drive bracket to the hard drive. Separate the hard-drive bracket from the hard drive.Installing the Hard Dri

3. Disconnect the coin-cell battery cable from its connector on the system board.4. Lift and remove the coin-cell from the computer.Installing the Coi

3. Connect the antenna cables to their respective connectors marked on the WLAN card.4. Install :a) batteryb) base coverc) optical drive5. Follow the

4. Lift and remove the heat sink from the computer.Installing the Heat Sink1. Place the heat sink into its original position on the system board.2. Ti

Removing the Speakers1. Follow the procedures in Before Working Inside Your Computer.2. Remove:a) optical driveb) base coverc) battery3. Disconnect th

Installing the Speakers1. Place the speakers into its original position on the computer.2. Route the speaker cable along the routing channel.3. Connec

Installing the Camera1. Align the camera to the base panel .2. Connect the camera cable to the camera.3. Install :a) display bezelb) batteryc) base co

b) base coverc) optical drive5. Follow the procedures in After Working Inside Your Computer.Removing the Display Assembly1. Follow the procedures in B

Notes, Cautions, and WarningsNOTE: A NOTE indicates important information that helps you make better use of your computer.CAUTION: A CAUTION indicates

Installing the Display Assembly1. Align the base panel of the computer to the display hinges.2. Install the screws that secure the display hinges to t

e) heat sinkf) memoryg) display assembly3. Disconnect the following cables:a) speakerb) displayc) keyboardd) touchpade) cameraf) coin cell batteryg) h

Installing the System Board1. Place the system board into its original position on the chassis.2. Install the screws that secure the system board to t

Removing the Display Bezel1. Follow the procedures in Before Working Inside Your Computer.2. Remove:a) optical driveb) base coverc) batteryd) display

a) optical driveb) base coverc) batteryd) display assemblye) display bezel3. Remove the screws that secure the display to the back panels.4. Gently li

Installing the Display1. Connect the LVDS cable to the back of the display panel and stick the mylar tape. Align the display to the base panel by pres

26

3System SetupSystem Setup OverviewSystem Setup allows you to:• change the system configuration information after you add, change, or remove any hardwa

NOTE: For most of the system setup options, changes that you make are recorded but do not take effect until you restart the system.Table 1. Navigation

System Setup OptionsMainTable 2. MainSystem Time Re-sets the time on the computer's internal clock.System Date Re-sets the date on the computer&a

ContentsNotes, Cautions, and Warnings...21 Working on

is enabled only when the AC adapter is connected.SATA Operation Change the SATA controller mode to either ATA or AHCI.Default: AHCIAdapter WarningsFun

Load Legacy Option Boot Allows you to load legacy option. (Default: Disabled)Boot List Option Allows you to view the boot options.Add Boot Option Allo

32

4Troubleshooting Your ComputerYou can troubleshoot your computer using indicators like Diagnostic Lights, Beep Codes, and Error Messages during the op

Battery Charge LED Off/Hibernate StandbyBattery mode Discharging when Battery charge is > 10%Off OffDischarging when Battery charge is <=10%Off

BeepsDescription Possible Cause / Suggested Remedy2. If the problem persists, possible battery failure or system board failure.6 Video BIOS test failu

36

5Technical SpecificationNOTE: Offerings may vary by region. For more information regarding the configuration of your computer, click Start (Start ico

Feature DescriptionStereo conversion 2.1Speakers 3Volume controls Function Keys (<F8>–<F12>)Table 11. VideoFeature DescriptionVideo type U

Table 15. DisplayFeature DescriptionType HDDimensions:Height 205.6 mm (8.09 inches)Width 320.9 mm (12.63 inches)Diagonal 15.6"Active area (X/Y) 3

Installing the System Board...

Feature DescriptionCharge time 3 hourVoltage 11.4 VTemperature range:Operating 0 ℃ to 50 ℃Non-Operating 0 ℃ to 65 ℃Coin-cell battery 3 V CR2032 lithiu

Feature DescriptionStorage 20% – 95%Altitude (maximum):Operating–15.2 m to 3048 m (–50 to 10,000 ft)0° to 35°CNon-Operating –15.2 m to 10,668 m (–50

42

6Contacting Dell To contact Dell for sales, technical support, or customer service issues:1. Visit support.dell.com. 2. Verify your country or region

1Working on Your ComputerBefore Working Inside Your ComputerUse the following safety guidelines to help protect your computer from potential damage an

CAUTION: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the c

2Removing and Installing ComponentsThis section provides detailed information on how to remove or install the components from your computer.Recommende

1. woofer2. system fan3. heat sink4. display cable5. WLAN card6. memory7. system board8. coin-cell battery9. battery10. hard drive11. speaker12. I/O b

4. Pry the base cover along the edges to loosen it. Lift and remove the base cover from the computer.9