Dell E5250 Uživatelský manuál stáhnout pdf (Strana 19)

Installing the SmartCard-Reader Board

1. Place the SmartCard-reader board into its slot on the palmrest.

2. Tighten the screws to secure the SmartCard-reader board to the palmrest.

3. Fix the SmartCard-reader cable and connect the SmartCard-reader cable to its connector on the

USH board.

4. Install the:

a. palmrest

b. keyboard

c. keyboard trim

d. battery

e. base cover

5. Follow the procedures in After Working Inside Your Computer.

Removing the USH Board

NOTE: This component is sold separately and is not shipped with the computer.

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove the:

a. base cover

b. battery

c. hard-drive assembly

d. keyboard trim

e. keyboard

f. palmrest

3. Perform the following steps to remove the USH board:

a. Disconnect all the cables from the USH board [1] [2].

b. Remove the screw that secures the USH board to the palmrest [3].

c. Remove the USH board from the palmrest [4].

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 61 62

Žádné komentáře

Dell E5250 Uživatelský manuál Strana 19