Dell Broadcom NetXtreme Family of Adapters Uživatelská příručka stáhnout pdf (Strana 320)

NetXtreme II User Guide

September 2013

Broadcom Corporation

Page 320 Running a Cable Length Test Document INGSRVT78-CDUM100-R

RUNNING A CABLE LENGTH TEST

For Windows operating systems, see Analyzing Cables in Windows for information on running a cable length test. Cable

analysis is not available for NetXtreme II 10 GbE network adapters.

TESTING NETWORK CONNECTIVITY

NOTE: When using forced link speeds, verify that both the adapter and the switch are forced to the same speed.

WINDOWS

Network connectivity can be tested using the Testing the Network feature in Broadcom Advanced Control Suite.

An alternate method is to use the ping command to determine if the network connection is working.

1. Click Start, and then click Run.

2. Type cmd in the Open box, and then click OK.

3. Type ipconfig /all to view the network connection to be tested.

4. Type ping IP address, and then press ENTER.

The ping statistics that are displayed indicate whether the network connection is working or not.

LINUX

To verify that the Ethernet interface is up and running, run ifconfig to check the status of the Ethernet interface. It is possible

to use netstat -i to check the statistics on the Ethernet interface. See Linux Driver Software for information on

ifconfig and

netstat.

Ping an IP host on the network to verify connection has been established.

From the command line, type ping IP address, and then press ENTER.

The ping statistics that are displayed indicate whether or not the network connection is working.

1 2 ... 315 316 317 318 319 320 321 322 323 324 325 ... 331 332

Žádné komentáře

Dell Broadcom NetXtreme Family of Adapters Uživatelská příručka Strana 320