Dell Force10 Z9000 Příručka pro rychlý start stáhnout pdf (Strana 19)

Installing the Software 17

Default Configuration

A version of the FTOS is pre-loaded onto the Z9000 system; however, the

system is not configured when you power up for the first time (except for the

default hostname, FTOS). You must configure the system using the CLI.

Configure Layer 2 (Data Link) Mode

To enable Layer 2 data transmissions through an individual interface, use the

switchport command in INTERFACE mode. You cannot configure switching

or Layer 2 protocols such as Spanning Tree Protocol (STP) on an interface

unless the interface has been set to Layer 2 mode.

To enable an interface in Layer 2 mode, follow these steps:

To view interfaces in Layer 2 mode, use the show interfaces switchport

command in EXEC mode.

Configure a Host Name

The host name appears in the prompt. The default host name is FTOS. Host

names must start with a letter, end with a letter or digit, and have letters, digits,

and hyphens within the string.

To configure a host name, follow this step:

Step Task Command Syntax Command Mode

1 Enable the interface. no shutdown INTERFACE

2 Place the interface in

Layer 2 (switching)

mode.

switchport INTERFACE

Task Command Syntax Command Mode

Create a new host name. hostname name CONFIGURATION

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Žádné komentáře

Dell Force10 Z9000 Příručka pro rychlý start Strana 19