Dell Active Fabric Manager Uživatelská příručka Strana 63

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 179
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 62
example shown below, a Layer 3 with Resiliency (Routed VLT) fabric. Based on the deployment type option selected,
different downlinks options are configured at the access tier.
The following section lists the topology types that you can select:
1. Layer 3 with Resiliency (Routed VLT) with stacking option – When you select the Stacking option, configure the
VLAN with the primary and secondary IP addresses for each access switch.
Figure 22. 3 Tier Layer 3 with Resiliency (Routed VLT) with Stacking Option
2. Layer 3 with Resiliency (Routed VLT) with VLT option – When you select the VLT option, the default configuration
is to enter the VLAN ID, Primary IP address and Secondary address. If you select the Enable Layer 3 Protocol in
Access Switches option, configure the VLAN ID and then the IP Range. When you complete the pre-deployment
configuration, the Advanced VLAN IP Configuration option is available at the Configure and Deploy summary
screen.
63
Zobrazit stránku 62
1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 178 179

Komentáře k této Příručce

Žádné komentáře