Dell N2000 Jak používat stáhnout pdf (Strana 7)

7 Using MLAG in Dell Networks

Change any settings mentioned below on both

the MLAG peers when required. Enable MLAG only after

the above settings are configured on the two peer switches.

It is also recommended for MLAG to be temporarily disabled in order to make subsequent changes to the

above settings.

Note: Be sure to schedule down time if making changes that impact traffic or cause data loss.

Note: Failure to make these areas identical may cause sporadic traffic issues on the network which are

difficult to troubleshoot.

Option category

Settings that need to match on both MLAG peers

Link Aggregation

Hashing mode

Minimum links

Static/dynamic LAG

LACP parameters

o Actor parameters

o Admin key

o Collector max-delay

o Partner parameters

Spanning Tree

Bpdufilter

Bpduflood

Auto-edge

TCN-guard

Cost

Edgeport

Root guard

Loop guard

STP Version

STP MST VLAN configuration

1. STP MST instance configuration (instance ID,

port priority, port cost/mode)

MLAG Port-channels

Port-channel mode

Link speed

Duplex mode

MTU

Bandwidth

VLAN configuration

Interfaces

PFC configuration

CoS queue assignments

VLANs

MLAG VLANs must be configured on both

MLAG peers, and connect to two partner LAGs.

Firmware

Both peers require the same firmware version

to operate correctly.

Misc.

FDB entry aging timers

Static MAC entries

ACL configuration

Table 1 Specific configuration options to be equal among MLAG peers

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Komentáře k této Příručce

Žádné komentáře

Dell N2000 Jak používat Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Sítě Dell N2000