Dell PowerConnect W-Airwave 8.0 Instalační manuál stáhnout pdf (Strana 7)

6. Select the appropriate number or processors, and then specify the minimum virtual RAM. Refer to the Dell

Networking W-AirWave 8.0 Server Sizing Guide.

7. Accept the VMware default virtual network adapter, and click Next.

8. Allocate a virtual disk large enough to contain the AirWave operating system, application, and data files. Refer to

the Dell Networking W-AirWave 8.0 Server Sizing Guide.

9. Review the virtual machine settings, and then click Finish when you are done.

Installing AirWave on the Virtual Machine

Installing AirWave on a VMware virtual machine is typically done in one of three ways:

l By writing an AirWave ISO to DVD, inserting the DVD into a physical drive on a VMware server, and then

configuring the AirWave virtual machine to boot from the DVD.

l By copying the AirWave ISO to the VMware server's datastore or to a networked filesystem available to the VMware

server, and then configuring the AirWave virtual machine to boot from the ISO file.

l By using either a local physical DVD or an AirWave ISO file from the VMware Infrastructure Client, and then

creating a virtual CD on the virtual AirWave to point to and boot from that device.

Overall, the second option is likely the most efficient method to install AirWave. After booting the AirWave virtual

machine with either a physical DVD or the ISO image file, the installation process with this method is identical to the

steps outlined earlier in this document.

Installing in a Hyper-V Environment

This section provides information on installing AirWave on Hyper-V. This section includes the following topics.

l "Prerequisites" on page 7

l "Installing AirWave on the Virtual Machine" on page 8

Prerequisites

l AirWave has been tested in-house using the Hyper-V Manager on a Windows Server 2000 R2.

l A legacy network adapter must be configured in order to install in a Hyper-V virtual environment. Follow the steps

below before installing AirWave.

1. During the initial setup of the virtual machine, specify to add a new Legacy Network Adapter in the Add

Hardware section. The image is similar to below.

Figure 2:Add a Legacy Network Adapter

2. Click Add. In the left pane, select the legacy network adapter, and configure its settings in the right pane.

Dell Networking W-AirWave 8.0 | Installation Guide 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Žádné komentáře

Dell PowerConnect W-Airwave 8.0 Instalační manuál Strana 7