
support.dell.com
Upgrading Your Dell PowerVault Fibre Channel Software and Firmware 9-7
To update the NVRAM and the BIOS, perform the same steps as in “Configuring the
HBA” in Chapter 10.
To update the HBA drivers in NetWare, perform the following steps:
1. I n s e r t t h e
Dell PowerVault Fibre Channel Utilities CD Version 4.0
into the server’s
CD-ROM drive, or insert driver and firmware diskette 1 that you made from the
CD into the server's diskette drive.
2. Start the appropriate NetWare installation program.
• For NetWare 4.2, type load install at the server console prompt.
• For NetWare 5.1, type load nwconfig at the server console prompt.
3. Select Driver Options.
4. Select Configure disk and storage device drivers.
5. Select Deselect a selected driver.
NOTE: Unloading the selected driver unmounts all LUNs.
6. Select QL2100.HAM or QL2200.HAM, depending on which adapter you have.
7. At the prompt Do you want to unload driver <driver_version>?,
select Ye s .
8. Go back to Configure disk and storage device drivers.
9. Select Select an additional driver.
10. Press <Insert> to select Install an unlisted driver.
11. If the driver and firmware diskette is in drive A, press <Enter>.
If the driver and firmware diskette is not in drive A, press <F3> to enter the cor-
rect path to the firmware and driver diskette.
12. Select QL2100.HAM or QL2200.HAM, depending on which adapter you have.
13. At the prompt Do you want to copy driver QL2100.HAM?,selectYe s .
14. At the prompt Specify server boot path, type the path to the file
server.exe, or press <Enter> to accept the default path of c:\nwserver.
15. At the prompt Save Existing File c:\nwserver\ql2x00.ham, select
No.
16. At the prompt Save Existing File c:\nwserver\ql2x00.ddi, select
No.
17. Select Modify driver parameters.
18. Type the proper value for Slot Number and press <Enter>.
Komentáře k této Příručce