Dell M630P Uživatelský manuál stáhnout pdf (Strana 61)

1. Ensure that you read the Safety instructions.

2. Keep the #2 Phillips screwdriver ready.

3. Remove the SD card.

4. Remove the IDSDM card, see Removing the IDSDM card.

CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.

Steps

1. Align the following:

• The slot on the card edge with the projection tabs on the PCIe mezzanine card support.

• The two screw holes on the IDSDM card with the standoffs on the system board.

• The hole on the SD card slot bracket with the screw hole on the IDSDM card.

2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.

Next steps

1. If applicable, install the SD card(s) and the internal USB key.

2. Follow the procedure listed in After working inside your system.

Related Links

Replacing an SD card

Replacing the internal USB key

rSPI card (optional)

rSPI (restore Serial Peripheral Interface) is a SPI flash device to store information about the system Service

Tag, system configuration, or iDRAC license.

Removing the rSPI card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only

perform troubleshooting and simple repairs as authorized in your product documentation, or as

directed by the online or telephone service and support team. Damage due to servicing that is

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that came with the product.

1. Ensure that you read the Safety instructions.

2. Keep the #2 Phillips screwdriver ready.

3. Follow the procedure listed in Before working inside your system.

Steps

1. Remove the two screws securing the rSPI card to the system board.

CAUTION: To prevent damage to the rSPI card, you must hold the card only by its edges.

2. Lift the card up and away from the system.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 114 115

Žádné komentáře

Dell M630P Uživatelský manuál Strana 61