Dell PowerEdge 800 Průvodce řešením problémů stáhnout pdf (Strana 44)

Back to Contents Page  
 Installing System Components  
Dell™PowerEdge™800SystemsInstallationandTroubleshootingGuide 
Cooling Shroud  
System Fans  
Power Supply  
Expansion Cards  
System Memory  
Processor  
Installing a RAC Card  
System Battery  
 
This section describes how to install the following system components: 
l Cooling shroud 
 
l System fans 
 
l Power supply 
 
l Memory modules 
 
l Processor 
 
l Expansion cards 
 
l System battery 
 
Cooling Shroud  
 
Removing the Cooling Shroud 
 
 
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.  
 
  
2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."  
 
  
3. Lay the system on its right side.  
 
  
4. Remove the cover. See "Removing the Cover" in "Troubleshooting Your System."  
 
  
5. Disconnect the power cables and hard-drive interface cable connectors from the SCSI backplane (if applicable) or hard drives.  
 
  
6. Press the shroud release tab on the back panel toward the power supply. See Figure6-1.  
 
  
7. Lift the cooling shroud out of the system. See Figure6-1.  
 
Figure 6-1. Removing the Cooling Shroud 
 
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting 
against electrostatic discharge. 

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 81 82

Komentáře k této Příručce

Žádné komentáře

Dell PowerEdge 800 Průvodce řešením problémů Strana 44

Komentáře k této Příručce

Související produkty a manuály pro Servery Dell PowerEdge 800