Dell PowerConnect W-Airwave 7.2 Uživatelský manuál stáhnout pdf (Strana 76)

76 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.2 | User Guide

9. To configure NTP settings locate the NTP section and adjust these settings as required. Table 42 describes

the settings and default values.

10. To configure settings specific to Cisco IOS/VxWorks, locate the Cisco IOS/VxWorks section and adjust these

settings as required. Table 43 describes the settings and default values.

Bridge Maximum

Age

20 Sets the maximum time, in seconds, that the device stores protocol information. The

supported range is from 6 to 40.

Bridge Hello

Time

2 Sets the time, in seconds, between Hello message broadcasts.

Bridge Forward

Delay

15 Sets the time, in seconds, that the port spends in listening and learning mode if the spanning

tree has changed.

Table 42 NTP Fields and Default Values

Setting Default Description

NTP Server #1,2,3 None Sets the IP address of the NTP server to be configured on the AP.

UTC Time Zone 0 Sets the hour offset from UTC time to local time for the AP. Times displayed in AWMS graphs and

logs use the time set on the AWMS server.

Daylight Saving

Time

No Enables or disables the advanced daylight saving time settings in the Proxim and HP ProCurve

420 sections of the Groups > Basic configuration page.

Table 43 Cisco IOS/VxWorks Fields and Default Values

Setting Default Description

SNMP Version 2c The version of SNMP used by AWMS to communicate to the AP.

Cisco IOS CLI

Communication

Telnet The protocol AWMS uses to communicate with Cisco IOS devices. Selecting SSH

uses the secure shell for command line page (CLI) communication. Selecting Telnet

sends the data in clear text via Telnet.

Cisco IOS Config File

Communication

TFTP The protocol AWMS uses to communicate with Cisco IOS devices. Selecting SCP

uses the secure copy protocol for file transfers. Selecting TFTP will use the insecure

trivial file transfer protocol. The SCP login and password should be entered in the

Telnet username and password fields.

Track Usernames on

Cisco Aironet

VxWorks APs

No Configures VxWorks APs to send SNMP packets to AWMS.

Table 41 Spanning Tree Protocol Fields and Default Values (Continued)

Setting Default Description

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 281 282

Komentáře k této Příručce

Žádné komentáře

Dell PowerConnect W-Airwave 7.2 Uživatelský manuál Strana 76

Komentáře k této Příručce

Související produkty a manuály pro Software Dell PowerConnect W-Airwave 7.2