Dell POWER VAULT 130T LIBRARY 130T Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Páskové jednotky Dell POWER VAULT 130T LIBRARY 130T. Dell POWER VAULT 130T LIBRARY 130T Installation guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 13
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
www.dell.com
®
Dell PowerVault
130T Library
DRIVE INSTALLATION GUIDE
Zobrazit stránku 0
1 2 3 4 5 6 ... 12 13

Shrnutí obsahu

Strany 1 - DRIVE INSTALLATION GUIDE

www.dell.com®Dell PowerVault™ 130T LibraryDRIVE INSTALLATION GUIDE

Strany 2

6 Drive Tray Assembly Conversion InstructionsFigure 4. Connecting the SCSI cableConnecting the SCSI cableCAUTION: The tape drive interface cable (P98

Strany 3

Drive Tray Conversion Instructions 79. Close the hinged door at the rear of the library.10. Tighten the two thumbscrews to secure the door.11. Connec

Strany 4

8 Drive Tray Assembly Conversion InstructionsScroll using the arrow buttons to select the correct drive (drives are numbered 0 through 3 starting fro

Strany 5 - DLT Drive Tray Assembly

®Printed in the U.S.A.5085D

Strany 7 - Parts Description

www.dell.com®Dell PowerVault™ 130T LibraryDRIVE INSTALLATION GUIDE

Strany 8 - Figure 3. Setting TermPwr

____________________Information in this document is subject to change without notice.© 1997–1998 Dell Computer Corporation. All rights reserved.Reprod

Strany 9 - Setting TermPwr

Drive Tray Conversion Instructions 1PowerVault 130T DriveInstallation InstructionsDLT Drive Tray AssemblyThese installation instructions describes ho

Strany 10 - Connecting the SCSI cable

2 Drive Tray Assembly Conversion InstructionsFigure 1. Back Vziew of Drive Tray AssemblyBack View of Drive Tray AssemblyItem NumberParts Description1

Strany 11

Drive Tray Conversion Instructions 3Figure 2. Interface Connection and PowerInterface Connection and Power2. Disconnect the power cable from the tape

Strany 12

4 Drive Tray Assembly Conversion Instructions5. Loosen the two thumbscrews at the rear of the drive assembly.6. Using both hands, remove the drive as

Strany 13 - Printed in the U.S.A

Drive Tray Conversion Instructions 5Setting TermPwr2. To check terminator power (TERMPWR), remove the two power supply cover screws using a Torx driv

Komentáře k této Příručce

Žádné komentáře