Dell 530 Uživatelský manuál stáhnout pdf (Strana 17)

Memory Riser Board Replacement 17

Removing Memory Riser Boards

CAUTION: Before you perform this procedure, see

"Precautionary Measures."

Remove the microprocessor airflow shroud.

2 Remove the memory riser board retention bracket (see the following

figure).

a Lift the retention bracket up to disengage it from the chassis.

b Lift the bracket away from the chassis.

NOTICE: To avoid damage to the memory riser board, press the securing clips

with equal force applied at each end of the memory socket.

Remove memory riser board A:

NOTE: To access the securing clips on the system board memory sockets,

it may be necessary to remove the fan for microprocessor 0. For

instructions on removing and installing the processor fan, see the

Service Manual

a Press the securing clips of system board memory socket 1 outward

simultaneously until riser board A pops out slightly from the

socket.

b Lift riser board A away from the retention brackets on riser

board B.

4 Remove memory riser board B:

a Press the securing clips of system board memory socket B outward

simultaneously until riser board B pops out slightly from the

socket.

b Lift riser board B away from socket 2.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 86 87

Žádné komentáře

Dell 530 Uživatelský manuál Strana 17