Dell PowerConnect W-Airwave 7.2 Uživatelský manuál stáhnout pdf (Strana 11)

Dell PowerConnect W AirWave 7.2 | Best Practices Guide Configuring AWMS for Global Dell PowerConnect W Infrastructure | 9

Chapter 2

Configuring AWMS for Global Dell

PowerConnect W Infrastructure

This chapter explains how to optimally configure AWMS to globally manage your Dell PowerConnect W

infrastructure, and contains the following topics:

 “Disabling Rate Limiting in AMP Setup > General” on page9

 “Entering Credentials in Device Setup > Communication” on page10

 “Setting Up Time Synchronization” on page11

 “Enabling Support for Channel Utilization & Statistics” on page11

Disabling Rate Limiting in AMP Setup > General

Enabling the SNMP Rate Limiting for Monitored Devices option above adds a small delay between each SNMP

Get request, thus the actual polling intervals will be longer than what is configured. For example, setting a 10-

minute polling interval will result in an actual 12-minute polling interval.

To disable rate limiting in AWMS, follow these steps:

1. Navigate to AMP Setup > General.

2. Locate the Performance section on this page.

3. In the SNMP Rate Limiting for Monitored Devices field, select No, as shown in Figure 2.

4. Select Save.

Figure 2 SNMP Rate Limiting in AMP Setup > General

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

Žádné komentáře

Dell PowerConnect W-Airwave 7.2 Uživatelský manuál Strana 11