Dell W-6000 Instalační manuál stáhnout pdf

Dell PowerConnect W-6000 Power Supply

Installation Guide

0510766-01 | March 2011 1

The Dell PowerConnect W-6000 Power Supply adapts electrical power for use with the W-6000. The W-6000

chassis has three slots that can hold individual power supplies to support load sharing and fault tolerance.

This chapter describes the general features and physical characteristics of the power supply and important power

consumption management information. The final sections of the chapter cover the steps required to insert and

remove power supplies.

Features

Rating

The Dell W-6000 Power Supply (HW-PSU-400) is rated at 400 W total output and is auto-ranging to accept 85

to 264 VAC, at 50 to 60 Hz. Up to three 400 W power supplies can be installed in the W-6000.

Load Sharing

Load sharing occurs when more than one power supply of the same rating are installed in the W-6000 and turned

on. Load sharing divides the total power load of the W-6000 among all plugged in power supply modules. Since

the power supplies work together, the effective power capacity of the chassis is increased with each additional

power supply.

Redundancy

When multiple power supplies are installed, if one becomes unavailable (fails, or is turned off or removed) the

remaining power supplies will attempt to provide full power for the W-6000. If the total power load does not

exceed the combined rated output of the remaining, operational power supplies, the W-6000 will continue to

operate. For more information on power supply configurations, “Power Management” on page3.

Hot Swap

Hot swapping should be performed by a trained technician. Hot swapping allows you to replace one failed power

supply while the others provide full power. This makes it unnecessary to shut down the W-6000 during the

replacement procedure.

Hot swapping requires that after the target power supply is removed, the total power load does not exceed the

combined rated output of the remaining power supplies.

1 2 3 4 5 6

Shrnutí obsahu

Strany 1 - Installation Guide

Dell PowerConnect W-6000 Power SupplyInstallation Guide0510766-01 | March 2011 1The Dell PowerConnect W-6000 Power Supply adapts electrical power for

Strany 2 - Physical Description

2 Dell PowerConnect W-6000 Power Supply | Installation GuidePhysical DescriptionFigure 1 400W Power SupplyModule Fastening Screws: These two captive

Strany 3 - Inserting a Power Supply

Dell PowerConnect W-6000 Power Supply | Installation Guide 3Power Switch: The power switch has two states: Off () and On (|).Power ManagementThe W-60

Strany 4

4 Dell PowerConnect W-6000 Power Supply | Installation Guide3. Verify the power switch on the power supply to be installed is Off ().4. Insert the po

Strany 5 - Removing a Power Supply

Dell PowerConnect W-6000 Power Supply | Installation Guide 5Depending on the W-6000’s total power load, you may be required to increase the capacity o

Strany 6 - Contacting Support