Dell Acceleration Appliances for Databases Uživatelský manuál stáhnout pdf (Strana 31)

If the host name has changed, the service restarts, and the login process is initiated again.

After re-direction, the login dialog appears again.

6. Log in with the same username and password as before.

The software is now configured so you can begin to manage your ION Accelerator

appliance. The Overview screen appears, as shown in the Basic Tasks and Overview Tab

section.

For items not covered in the steps above, see Remote Access

in the Configuring ION

Accelerator Settings section.

To change the admin password, see Changing the Admin Password in the Tabs Bar section. For

details on managing admin and user passwords, see Users in the Configuring ION Accelerator

Settings section of this guide.

The admin account allows up to 10 concurrent sessions to run on the ION Accelerator appliance.

7. Once you are logged in to ION Accelerator, proceed to the ION Accelerator Appliance GUI

Guide for instructions on how to set up and manage your ioMemory storage.

CHANGING NODE NAMES AND IP ADDRESSES

This section explains how to change the names or IP addresses for ION Accelerator nodes once they

have been configured in the First Boot process. For details on using the

system:setup command

referred to in this section, refer to the ION Accelerator CLI Reference.

Changing a Node Name in a Cluster

Changing a node name requires cluster downtime.

1. Ensure that both nodes are up.

2. Close all active sessions by disabling or disconnecting all target ports.

3. In the CLI, run

system:setup lan to display the Setup dialog for LAN configuration.

4. Change the name of the node in the dialog.

5. Select OK and press Enter. Both nodes will restart, one at a time.

6. Repeat the previous two steps for the second node in the cluster.

31.41

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 88 89

Žádné komentáře

Dell Acceleration Appliances for Databases Uživatelský manuál Strana 31