Dell PowerVault DP100 Uživatelský manuál stáhnout pdf (Strana 2)

Back to Contents Page

 About Your System

Dell™PowerVault™100SystemsHardwareOwner'sManual

This section describes the physical, firmware, and software interface features that provide and ensure the essential functioning of your system. The physical

connectors on your system's front and back panels provide convenient connectivity and system expansion capability. The system firmware, applications, and

operating systems monitor the system and component status and alert you when a problem arises. System conditions can be reported by any of the following:

l Front or back panel indicators

l System messages

l Warning messages

l Diagnostics messages

l Beep codes

l Alert messages

This section describes each type of message, lists the possible causes, and provides steps to resolve any problems indicated by a message. The system

indicators and features are illustrated in this section.



Other Information You May Need



l The Getting Started Guide provides an overview of system features, setting up your system, and technical specifications.

l CDs included with your system provide documentation and tools for configuring and managing your system.

l Systems management software documentation describes the features, requirements, installation, and basic operation of the software.

l Operating system documentation describes how to install (if necessary), configure, and use the operating system software.

l Documentation for any components you purchased separately provides information to configure and install these options.

l Updates are sometimes included with the system to describe changes to the system, software, and/or documentation.

l Release notes or readme files may be included to provide last-minute updates to the system or documentation or advanced technical reference material

intended for experienced users or technicians.

Accessing System Features During Startup

Table1-1 describes keystrokes that may be entered during startup to access system features. If your operating system begins to load before you enter the

keystroke, allow the system to finish booting, and then restart your system and try again.

Table 1-1.KeystrokesforAccessingSystemFeatures

Other Information You May Need

System Messages

Accessing System Features During Startup

System Beep Codes

Front-Panel Features and Indicators

Warning Messages

Back-Panel Features and Indicators

Diagnostics Messages

Diagnostics Indicator Codes

Alert Messages

Hard-Drive Indicator Codes

Baseboard Management Controller Messages

CAUTION: The Product Information Guide provides important safety and regulatory information. Warranty information may be included within

this document or as a separate document.

NOTE: Always check for updates on support.dell.com and read the updates first because they often supersede information in other documents.



Keystroke



Description

<F2>

Enters the System Setup program. See Using the System Setup Program.

<F10>

Opens the utility partition, allowing you to run the system diagnostics. See

Running the System Diagnostics.

<Ctrl+E>

Enters the Baseboard Management Controller (BMC) Management Utility, which

allows access to the system event log (SEL). See the BMC User's Guide for more

information on setup and use of BMC.

<Ctrl+C>

Enters the SAS Configuration Utility. See your SAS adapter User's Guide for more

information.

<Ctrl+R>

Enters the RAID configuration utility, which allows you to configure an optional

RAID card. For more information, see the documentation for your RAID card.

1 2 3 4 5 6 7 ... 87 88

Komentáře k této Příručce

Žádné komentáře

Dell PowerVault DP100 Uživatelský manuál Strana 2

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Dell PowerVault DP100