Dell PowerVault DP100 Uživatelský manuál stáhnout pdf (Strana 36)



Installing the Front-Panel Drive Inserts



1. Install the chassis drive insert by sliding the insert into the chassis until tabs on the side of the insert snap into place. See Figure3-4.



2. Install the bezel drive insert by sliding the insert into the bezel until the tabs on the side of the insert snap into place. See Figure3-4.



3. Install the bezel. See Installing the Bezel.



4. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Closing the System



Replacing the Cover



1. Ensure that all cables are connected, and fold cables out of the way.



2. Ensure that no tools or loose parts are left inside the system.



3. Fit the cover on the side of the system, and slide the cover backward.



4. Tighten the cover thumbscrew to secure the cover.



Installing the Bezel

To install the bezel, align the hooks at the bottom of the bezel, swing the top of the bezel toward the system, and press the bezel onto the system until it

snaps into place. Using the system key, lock the bezel.

Connecting Drives

chassis drive insert

bezel drive insert

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system.

Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the

computer, and protecting against electrostatic discharge.

NOTICE: You must install both inserts in an empty 5.25-inch drive bay to maintain Federal Communications Commission (FCC) certification of the

system. The inserts also help keep dust and dirt out of the system.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 87 88

Komentáře k této Příručce

Žádné komentáře

Dell PowerVault DP100 Uživatelský manuál Strana 36

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Dell PowerVault DP100