Dell PowerVault NX3500 Uživatelský manuál stáhnout pdf (Strana 46)

46 About Your Solution

Warning: Control

Panel is not

installed.

The control panel is not

installed or has a faulty cable

connection.

Install the control panel, or

check the cable connections

between the display module,

the control panel board,

and the system board.

See "Control Panel

Assembly" on page 81.

Warning! No micro

code update

loaded for

processor n.

Micro code update failed. Update the BIOS firmware.

See "Getting Help" on

page 113.

Warning! Power

required exceeds

PSU wattage.

Check PSU and

system

configuration.

Warning!

Performance

degraded. CPU and

memory set to

minimum

frequencies to

meet PSU wattage.

System will

reboot.

The system configuration of

processor, memory modules,

and expansion cards may not

be supported by the power

supplies.

If any system components

were just upgraded, return

the system to the previous

configuration. If the system

boots without this warning,

then the replaced

component(s) are not

supported with this power

supply. If Energy Smart

power supplies are installed,

replace them with the High

Output power supplies to

use the components. See

"Power Supplies" on page 77.

Warning! PSU

mismatch. PSU

redundancy lost.

Check PSU.

A High Output power supply

and an Energy Smart power

supply are installed in the

system at the same time.

Install two High Output or

two Energy Smart power

supplies in the system.

You can also run the system

on one power supply until

you can obtain two power

supplies of the same type.

See "Troubleshooting Power

Supply" on page 96.

Table 1-4. System Messages

(continued)

Message Causes Corrective Actions

book.book Page 46 Monday, January 24, 2011 12:24 PM

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 117 118

Komentáře k této Příručce

Žádné komentáře

Dell PowerVault NX3500 Uživatelský manuál Strana 46

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Dell PowerVault NX3500