Dell UPS 1920T Uživatelský manuál Strana 12

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 88
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 11
12
|
Getting Started
Installing the Card
The Dell Network Management Card can be installed in any Dell UPS equipped with a communication
bay without turning off the UPS or disconnecting the load.
To install the Dell Network Management Card:
1 Remove the communication bay cover from the UPS. Retain the screws.
2 If not already done, record the card's MAC address for future reference (see “Installation
Checklist” on page 9).
3 To prevent electrostatic discharge (ESD), place one hand on a metal surface.
4 Slide the card into the open slot and secure with the screws removed in Step 1 (see Figure 4).
Figure 4. Installing the Card
Connecting the Card
To connect the card to the computer and start the configuration:
1 Plug the RJ-45 end of the supplied serial cable into the Settings port on the card (see Figure 5).
NOTE:
You can set the card parameters through the Settings port even if the network is not connected. The
Ethernet port on the card does not work for configuration.
2 Plug the other end of the serial cable into the serial COM port on the computer.
Zobrazit stránku 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 87 88

Komentáře k této Příručce

Žádné komentáře