Dell XPS 710 Uživatelský manuál stáhnout pdf (Strana 40)



5. Insert the module into the connector until the module snaps into position.

If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.



6. Replace the computer cover (see Replacing the Computer Cover).



7. Connect your computer and devices to electrical outlets, and turn them on.



8. When the message appears stating that memory size has changed, press <F1> to continue.



9. Log on to your computer.



10. Right-click the My Computer icon on your Windows desktop and click Properties.



11. Click the General tab.



12. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.



Removing Memory



1. Follow the procedures in Before You Begin.



2. Press out the securing clip at each end of the memory module connector.



3. Grasp the module and pull up.

If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.

Cards



cutouts (2)

memory module

notch

crossbar



NOTICE: To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the

module.

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge and damage to internal components, ground yourself by using a wrist grounding strap or by periodically

touching an unpainted metal surface on the computer chassis.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 104 105

Žádné komentáře

Dell XPS 710 Uživatelský manuál Strana 40