Dell PowerVault NX3000 Uživatelský manuál stáhnout pdf (Strana 86)

86 Installing System Components

Figure 3-7. Removing and Installing a Power Supply

Replacing a Power Supply

On a system with redundant power supplies, verify that both power

supplies are the same type and have the same maximum output power.

NOTE: The maximum output power (shown in watts) is listed on the power

supply label.

Slide the new power supply into the chassis until the power supply is fully

seated and the release latch snaps into place. See Figure 3-7.

NOTE: If you unlatched the cable management arm in step 2 of the previous

procedure, relatch it. For information about the cable management arm, see

the system’s rack documentation.

Connect the power cable to the power supply and plug the cable into a

power outlet.

CAUTION: When connecting the power cable, secure the cable with the Velcro

strap.

1 power supply handle 2 Velcro strap

3 release latch

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 115 116

Žádné komentáře

Dell PowerVault NX3000 Uživatelský manuál Strana 86