Dell PowerVault NX3000 Uživatelský manuál stáhnout pdf (Strana 92)

92 Installing System Components

Install the iDRAC6 Enterprise card:

Angle the card so that the RJ-45 connector fits through the back-panel

opening. See

Figure 3-10.

Align the front edge of the card with the two front plastic retention

standoffs next to the iDRAC6 connector on the system board. See

Figure 6-2 for the location of the connector.

Press the card down until it is fully seated. See Figure 3-10.

When the front of the card is fully seated, the plastic standoffs snap

over the edge of the card.

Reinstall all expansion cards in expansion-card riser 1. See "Installing an

Expansion Card."

Close the system. See "Closing the System."

Reconnect the system and peripherals to their power sources, and turn

them on.

Figure 3-10. Removing and Installing the iDRAC6 Enterprise Card

1 iDRAC6 Enterprise card 2 VFlash media slot

3 VFlash SD card 4 RJ-45 Ethernet port (underneath

card)

5 retention standoff posts (2) 6 iDRAC6 Enterprise card connector

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 115 116

Žádné komentáře

Dell PowerVault NX3000 Uživatelský manuál Strana 92