
Dell
System 310/310R
IBM Document: Dell 02/97 Doc # MT00-014
Page 1 of 3
Copyright International Business Machines, 1997
Dell System 310/310R
Specifications
Processor
• Intel 80386/20
Memory
• 1MB standard, expands to 16MB
I/O Expansion Slots
• 2-8 bit and 6-16 bit expansion slots
Diskette Drive
• • 1.2MB diskette drive
Integrated Features
• • Parallel, 2-serial, keyboard, VGA, speaker
Internal Expansion Bays
• 2-user accessible bays, 2-internal bays
I/O Architecture
• • Industry Standard Architecture ISA
Power Supply
• 200 watts
Diagnostics
• Normal Post Diags performed on Power UP of system.
• Instead of Dell system support diskette use QAPlus/FE.
• • Troubleshoot according to errors found during test
CMOS Access
• QAPlus/FE
Tools and Software Requirements
• Flat bladed screwdriver
• Needle nose pliers
• Anti-static wrist strap
• • Diagnostics and formatted blank diskettes
Jumper Settings WD1003-WA2 Card
Jumper Function
E2 -E3* Selects primary addresses
E5-E6* Selects primary addresses
E1-E2 Selects secondary address
E4-E5 Selects secondary address
E7-E8 BIOS selects data transfer rate, controller
supports all data rates
E8-E9 300Kbps data rate not supported, controller
automatically switches to 250Kbps when
300Kbps rate is selected
* Do not remove primary address jumpers unless the OS is
configured to accept two hard disk drive controllers.
Jumper Settings WD1007A-WA2/WAH Card
WA2
Jmpr
Pin WAH
Jmpr
Pin Function
W1 2-3 W1 2-3 BIOS addr (C8000-
C9FFF)
W2 2-3 W2 2-3 BIOS addr (C8000-
C9FFF)
W3 jmpr W3 jpr BIOS shadow RAM on
W4 no jpr Dsktte drv cntrlr on
W5 no jpr single spindle speed on
W6 2-3 Dsktte drv addr (3FX)
W7 1-2 Dsktte drv type
W8 no jpr W8 no jpr WD1007 mode
W9 no jpr W9 no jpr Chassis not connected
W10 no jpr W10 no jpr Digital input unlatched
W11 jpr W11 no jpr Dsktte change on
W12 no jpr W12 no jpr Secondary addr (1FX)
W13 uncut Dsktte drv cntrlr on etch
W14 no jpr W14 no jpr Sector translation on
W15 no jpr W15 no jpr ECC length (4 bytes)
Note: WD1007A-WA2 supports up to 2 diskettes & 2 hard
drives. The WD1007A-WAH supports up to 2 hard drives.
Address Select
Jumper Settings WD1003-WAH/WA2 Card
W1 W2 W3 Function
2-3 2-3 Jumper BIOS addr. C8000-C9FFF
2-3 1-2 Jumper BIOS addr. CA000-CBFFF
1-2 2-3 Jumper BIOS addr. CC000-CDFFF
1-2 1-2 Jumper BIOS addr. CE000-CFFFF
W6
1-2 diskette range 37X
2-3 diskette range 3FX
W12
No jpr Pri/Sec HD addr 1FX
Jumper Pri/Sec HD addr 17X
Komentáře k této Příručce