Dell Force10 E300 Uživatelská příručka stáhnout pdf (Strana 3)

TeraScale to ExaScale Upgrade Procedure 3

Automatic upgrade during boot, reboot, reload, or restart

The FPGA auto upgrade takes place when any SFMs in the chassis run an FPGA version lower than the version

running during the boot, reboot, reload and restart operations. During the auto upgrade process, the system displays

messages relaying the status of the upgrade process (Figure 1). To verify the result of the SFM version upgrade, use

the

show sfm command.

Figure 1 FPGA Automatic Upgrade Messages

Verify the result of the SFM version upgrade using the show sfm command.

**************************************************************************

* Warning !!! Warning !!! Warning !!!

* -------------------------------------------------------------------------------------

* Starting auto upgrade of SFMs to newer version 0x0.0.3

* Please wait until upgradation of all 5 SFMS is complete.

* SFM will restart itself after upgradation of all 5 SFM is complete !

**************************************************************************

SFM 0/5 upgrade started

SFM 0/5 is upgraded to revision 0x0.0.3.

SFM 1/5 upgrade started

SFM 1/5 is upgraded to revision 0x0.0.3.

SFM 2/5 upgrade started

SFM 2/5 is upgraded to revision 0x0.0.3.

SFM 3/5 upgrade started

SFM 3/5 is upgraded to revision 0x0.0.3.

SFM 4/5 upgrade started

SFM 4/5 is upgraded to revision 0x0.0.3.

*************************************************************

* Warning !!! Warning !!! Warning !!!

* -----------------------------------------------------------

* Auto upgrade on all 5 SFM to version 0x0.0.3 is complete.

* Rebooting chassis .... !!!

*************************************************************

1 2 3 4 5 6 7 8

Žádné komentáře

Dell Force10 E300 Uživatelská příručka Strana 3