Dell OptiPlex XE (Early 2010) Dust Filter Instalační manuál

Procházejte online nebo si stáhněte Instalační manuál pro ne Dell OptiPlex XE (Early 2010) Dust Filter. Dell OptiPlex XE (Early 2010) Dust Filter Installation Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 4
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
About Warnings
WARNING: A WARNING indicates a potential for property damage, personal injury,
or death.
Installing Dust Filter on Your Dell™ OptiPlex™ XE
Dust filter helps reduce the dust particles from entering your computer.
WARNING: Before working inside your computer, read the safety information that
shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: The maximum operating temperature with the dust filter installed on a
Desktop Form Factor computer is 45 °C (113 °F).
NOTE: The maximum operating temperature with the dust filter installed on a
Small Form Factor computer with a 2.5 inch hard drive is 45 °C (113 °F) and with a
3.5 inch hard drive is 42 °C (107.6 °F).
1
Slide the dust filter inside the slot located on the bottom of the computer.
1 dust filter 2 dust filter slot
1
2
February 2010
Zobrazit stránku 0
1 2 3 4

Shrnutí obsahu

Strany 1 - About Warnings

About Warnings WARNING: A WARNING indicates a potential for property damage, personal injury, or death.Installing Dust Filter on Your Dell™ OptiPlex™

Strany 2 - Cleaning Your Dust Filter

Cleaning Your Dust FilterYou can clean the dust filter or replace it depending on the environment where the computer is used. CAUTION: Do not use a h

Strany 3 - Removing the Cable Cover

Removing the Cable Cover1Slide the release the latch on the cable cover and slide the cable cover out of the computer.2Disconnect all the cables from

Komentáře k této Příručce

Žádné komentáře