Dell PowerVault 124T Uživatelský manuál stáhnout pdf

www.dell.com | support.dell.com

Addendum to User’s Guide for the Dell PowerVault

124T Autoloader

Purpose of This Document

This PowerVault 124T Autoloader release (V53) includes support for Internet Protocol Version 6 (IPv6 Phase 1).

The

Dell PowerVault 124T User’s Guides

have not been updated for this release.

IPv6 Phase 1 Support

The PowerVault 124T autoloader now supports Internet Protocol Version 6 (IPv6 Phase 1).

Using IPv6 Phase 1 instead of or in addition to IPv4 does not affect autoloader functionality. However, setting up

network configuration is different for IPv6 Phase 1.

With both IPv4 and IPv6 Phase 1 enabled, the autoloader responds to remote access using the IP protocol

received. A Link local address is configured by the autoloader at boot time.

Internet Explorer does not recognize the IPv6 Phase 1 syntax. To access the Remote Management Unit (RMU)

of the autoloader using an IPv6 Phase 1 address from Internet Explorer, you must do one of the following:

•

Option 1

- Use IPv6 address FE80::2E0:9EFF:FE0D:D7CE as an example of an RMU address. Enter the

address into the address bar but replace all occurrences of "

" with "

" and add "

s6.ipv6-literal.net

", where

the number

after the letter

indicates your local system’s IPv6 Zone ID. You can determine your Zone ID

number by opening a command prompt window and entering the command

ipconfig

. This command

returns information specific to your local system’s addresses.

•

Option 2

- Modify the system’s hostname file to translate the IPv6 address.

•

Option 3

- Use an IPv6-enabled server.

Enabling IPv6 Phase 1

The PowerVault 124T autoloader is IPv6 Phase 1 enabled by default.

September 2007

1 2 3 4

Shrnutí obsahu

Strany 1 - 124T Autoloader

www.dell.com | support.dell.comAddendum to User’s Guide for the Dell PowerVaultTM 124T AutoloaderPurpose of This DocumentThis PowerVault 124T Autoload

Strany 2 - Viewing IPv6 Addresses

www.dell.com | support.dell.comConfiguring IPv6 Phase 1From the Operator Panel:• Select Configuration > Ethernet > Set IPv6 Addr.From any On Boa

Strany 3 - References

www.dell.com | support.dell.comReferencesPV124T RMU Access Methods MatrixNOTE: Hostfile access and/or Knowledge of your DNS settings are needed for ke

Strany 4 - ____________________