Dell Dimension L___cx Uživatelský manuál Strana 50

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 162
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 49
3-8 Dell Dimension L Series Systems Reference and Troubleshooting Guide
Figure 3-6. Locating Rails for the Upper 3.5-Inch Drive Bay
7. Slide the drive assembly into the drive bay.
8. If you are installing a controller card, configure and install it in an expansion slot pansion slot
now (refer to PCI Expansion Card Upgrades in Chapter 2 for instructions).
Install the card as close as possible to the drive cage.
NOTICE: Dell does not recommend routing cables over cards because the
cables can restrict airflow, cause cooling problems, and interfere with
removing and replacing the computer cover. If you must route cables over
cards, be extremely cautious when removing and replacing the computer
cover.
9. Connect a DC power cable to the drive as described earlier in Connecting Drive
Cables.
NOTICE: Match the colored strip on the cable with pin 1 on the interface
connector.
10.0. Attach the appropriate interface cable to the drive. If you installed a controller
card in step 8, attach the other end of the interface cable to the controller card
rather than the system board.
11. Replace the bezel.
front of chassis
left rail
right rail
Zobrazit stránku 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 161 162

Komentáře k této Příručce

Žádné komentáře