Dell Management Plug-in for VMware vCenter version 1.0.1 Uživatelský manuál Strana 96

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 114
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 95
96 Troubleshooting
In some cases, a firmware update may not have registered on the system; cold
booting the system or reseating the blade fixes this problem. The newly-
enabled account on the iDRAC must be disabled and auto-discovery re-
initiated to provide model info and NIC information to the plug-in.
Can the plug-in support ESX/ESXi with Lockdown mode enabled?
No. Lockdown mode is not supported in this release.
What setting should I use for UserVars.CIMoenProviderEnabled with ESXi 4.1 U1?
UserVars.CIMoemProviderEnabled must be set to 1.
Can the plug-in support multiple vCenters in linked mode?
No. The Plug-in does not support multiple vCenters in linked mode.
I am using a reference server to create a Hardware Profile, but it failed. What
should I do?
Check to make sure that minimum recommended versions of iDRAC
firmware, Lifecycle Controller firmware, and BIOS are installed.
To make sure that the data retrieved from the reference server is current,
enable Collect System Inventory On Restart (CSIOR), and restart the
reference server prior to extraction of data. See "Setting Collect System
Inventory on Restart (CSIOR) on a Clone Server" on page 65 for more
information.
I am attempting to deploy ESX/ESXi on a blade server, and the deployment job failed.
What should I do?
1
Make sure the ISO location (NFS path) and staging folder paths are
accurate.
2
Make sure the NIC selected during assignment of server identity is on the
same network as the Dell appliance.
3
If using static IP assignment, make sure the network information provided
(including subnet mask and default gateway) is accurate. Also, make sure
the IP address is not already assigned on the network.
4
Make sure at least one Virtual Disk is seen by the system; ESXi does not
install to the internal SD module.
Zobrazit stránku 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 113 114

Komentáře k této Příručce

Žádné komentáře