Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Uživatelský manuál Strana 11

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 81
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 10
Warning Messages
A warning message alerts you to a possible problem and prompts you to respond before the system continues a task. For example, before you format a
diskette, a message will warn you that you may lose all data on the diskette. Warning messages usually interrupt the task and require you to respond by
typing y(yes)orn (no).
Diagnostics Messages
When you run system diagnostics, an error message may result. Diagnostic error messages are not covered in this section. Record the message on a copy of
the Diagnostics Checklist in Getting Help, and then follow the instructions in that section for obtaining technical assistance.
Alert Messages
Systems management software generates alert messages for your system. Alert messages include information, status, warning, and failure messages for
drive,temperature,fan,andpowerconditions.Formoreinformation,seethesystemsmanagementsoftwaredocumentation.
Back to Contents Page
The following DIMMs are not
compatible: DIMM x and DIMM y
The specified DIMM(s) are incompatible with the
system.
Ensure that only ECC FBD1 memory is used. Dell recommends
purchasing memory upgrade kits directly from www.dell.com
or your Dell sales agent to ensure compatibility.
Time-of-day not set - please run
SETUP program
Incorrect Time or Date settings; faulty system
battery.
Check the Time and Date settings. See Using the System
Setup Program. If the problem persists, replace the system
battery. See System Battery.
Timer chip counter 2 failed
Faulty system board.
See Getting Help.
Unsupported CPU combination
Microprocessor(s) is not supported by the system.
Install a supported microprocessor or microprocessor
combination. See Processors.
Unsupported CPU stepping detected
Utility partition not available
The <F10> key was pressed during POST, but no
utility partition exists on the boot hard drive.
Create a utility partition on the boot hard drive. See the CDs
that came with your system.
NOTE: Warning messages are generated by either the application or the operating system. For more information, see the documentation that
accompanied the operating system or application.
Zobrazit stránku 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 80 81

Komentáře k této Příručce

Žádné komentáře