Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) Uživatelský manuál Strana 59

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 81
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 58
The password jumper enables these password features or disables them and clears any password(s) currently in use.
1. Turnoffthesystem,includinganyattachedperipherals,anddisconnectthesystemfromtheelectricaloutlet.
2. Open the system. See Opening and Closing the System.
3. Lift up the memory module shroud.
4. Remove the jumper plug from the password jumper.
See Figure6-1 to locate the password jumper on the system board.
5. Close the system.
6. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed. However, before you assign a new
systemand/orsetuppassword,youmustinstallthejumperplug.
7. Turnoffthesystem,includinganyattachedperipherals,anddisconnectthesystemfromtheelectricaloutlet.
8. Open the system. See Opening and Closing the System.
9. Install the jumper plug on the password jumper.
10. Lower the memory module shroud.
11. Close the system.
12. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
13. Assign a new system and/or setup password.
To assign a new password using the System Setup program, see Assigning a System Password.
System Board Connectors
See Figure6-2 and Table6-2 for the location and description of system board connectors.
Figure 6-2. System Board Connectors
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions in your ProductInformationGuide.
NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the system disables the new password(s) the next
time it boots.
Zobrazit stránku 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 80 81

Komentáře k této Příručce

Žádné komentáře