Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 209)

Sample Configurations

The following example configurations show how to enable BGP and set up some peer groups. These

examples are not comprehensive directions. They are intended to give you some guidance with typical

configurations.

To support your own IP addresses, interfaces, names, and so on, you can copy and paste from these

examples to your CLI. Be sure that you make the necessary changes.

The following illustration shows the configurations described on the following examples. These

configurations show how to create BGP areas using physical and virtual links. They include setting up the

interfaces and peers groups with each other.

Figure 24. Sample Configurations

Example of Enabling BGP (Router 1)

R1(conf)#int loop 0

R1(conf-if-lo-0)#ip address 192.168.128.1/24

R1(conf-if-lo-0)#no shutdown

R1(conf-if-lo-0)#show config

interface Loopback 0

ip address 192.168.128.1/24

Border Gateway Protocol IPv4 (BGPv4)

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 209