Dell Networking S6000 Uživatelský manuál Strana 386

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 986
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 385
Configuring Management Interfaces on the S-Series
You can manage the S-Series from any port.
To configure an IP address for the port, use the following commands. There is no separate management
routing table, so configure all routes in the IP routing table (the
ip route command).
Configure an IP address.
INTERFACE mode
ip address
Enable the interface.
INTERFACE mode
no shutdown
The interface is the management interface.
INTEFACE mode
description
Example of the show interface and show ip route Commands
To display the configuration for a given port, use the show interface command in EXEC Privilege
mode, as shown in the following example. To display the routing table, use the show ip route
command in EXEC Privilege mode.
Dell#show int gig 0/48
GigabitEthernet 0/48 is up, line protocol is up
Description: This is the Managment Interface
Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.240/23
[output omitted]
Dell#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.11.131.254, Gi 0/48 1/0 1d2h
C 10.11.130.0/23 Direct, Gi 0/48 0/0 1d2h
Dell#
VLAN Interfaces
VLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels
can be members of VLANs.
For more information about VLANs and Layer 2, refer to Layer 2 and Virtual LANs (VLANs).
386
Interfaces
Zobrazit stránku 385
1 2 ... 381 382 383 384 385 386 387 388 389 390 391 ... 985 986

Komentáře k této Příručce

Žádné komentáře