Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 419)

100

101

– For a Port Channel interface, enter the keywords port-channel then a number.

– For the management interface on the RPM, enter the keyword ManagementEthernet then the

slot/port information. The slot range is from 0 to 1. The port range is 0.

– For a SONET interface, enter the keyword sonet then the slot/ port information.

– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port

information.

– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

– For a VLAN, enter the keyword vlan then a number.

– (OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a

number from 1 to 255 as the vrid.

– (OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC

learning limit on the interface, enter the keywords learning-limit.

Example of the clear counters Command

When you enter this command, confirm that you want Dell Networking OS to clear the interface counters

for that interface.

Dell#clear counters gi 0/0

Clear counters on GigabitEthernet 0/0 [confirm]

Dell#

Enhanced Validation of Interface Ranges

This functionality is supported on the S6000 platform.

You can avoid specifying spaces between the range of interfaces, separated by commas, that you

configure by using the interface range command. For example, if you enter a list of interface ranges,

such as

interface range fo 2/0-1,te 10/0,gi 3/0,fa 0/0, this configuration is considered

valid. The comma-separated list is not required to be separated by spaces in between the ranges. You

can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-

address-table static multicast-mac-address vlan vlan-id output-range interface

command.

Compressing Configuration Files

The functionality to optimize and reduce the sizes of the configuration files is supported on the S6000

platform.

You can compress the running configuration by grouping all the VLANs and the physical interfaces with

the same property. Support to store the operating configuration to the startup config in the compressed

mode and to perform an image downgrade without any configuration loss are provided.

You can create groups of VLANs using the interface group command. This command will create

non-existant VLANs specified in a range. On successful command execution, the CLI switches to the

interface group context. The configuration commands inside the group context will be the similar to that

of the existing range command.

Two existing exec mode CLIs are enhanced to display and store the running configuration in the

compressed mode.

show running-config compressed and write memory compressed

Interfaces

419

1 2 ... 414 415 416 417 418 419 420 421 422 423 424 ... 985 986

Komentáře k této Příručce

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 419

Komentáře k této Příručce

Související produkty a manuály pro Software Dell Networking S6000