Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 687)

Figure 97. Load Balancing with PVST+

The bridge with the bridge value for bridge priority is elected root. Because all bridges use the default

priority (until configured otherwise), the lowest MAC address is used as a tie-breaker. To increase the

likelihood that a bridge is selected as the STP root, assign bridges a low non-default value for bridge

To assign a bridge priority, use the following command.

• Assign a bridge priority.

PROTOCOL PVST mode

vlan bridge-priority

The range is from 0 to 61440.

The default is 32768.

Example of the show spanning-tree pvst vlan Command

To display the PVST+ forwarding topology, use the show spanning-tree pvst [vlan vlan-id]

command from EXEC Privilege mode.

Dell_E600(conf)#do show spanning-tree pvst vlan 100

Per-VLAN Spanning Tree Plus (PVST+)

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 687