Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 526)

100

101

To set up and activate two or more connected interfaces, use the following commands.

1. Setup two or more connected interfaces for Layer 2 or Layer 3.

INTERFACE mode

ip address ip address, switchport

2. Activate the necessary ports administratively.

INTERFACE mode

no shutdown

INTERFACE mode

fefd {disable | interval | mode}

Example of Viewing FEFD Configuration

Dell(conf-if-gi-1/0)#show config

interface GigabitEthernet 1/0

no ip address

switchport

fefd mode normal

no shutdown

Dell(conf-if-gi-1/0)#do show fefd | grep 1/0

Gi 1/0 Normal 3 Unknown

Debugging FEFD

To debug FEFD, use the first command. To provide output for each packet transmission over the FEFD

enabled connection, use the second command.

• Display output whenever events occur that initiate or disrupt an FEFD enabled connection.

EXEC Privilege mode

debug fefd events

• Provide output for each packet transmission over the FEFD enabled connection.

EXEC Privilege mode

debug fefd packets

Examples of the debug fefd Commands

Dell#debug fefd events

Dell#config

Dell(conf)#int gi 1/0

Dell(conf-if-gi-1/0)#shutdown

2w1d22h: %RPM0-P:CP %IFMGR-5-ASTATE_DN: Changed interface Admin state to down:

Gi 1/0

Dell(conf-if-gi-1/0)#2w1d22h : FEFD state on Gi 1/0 changed from ANY to Unknown

2w1d22h: %RPM0-P:CP %IFMGR-5-OSTATE_DN: Changed interface state to down: Gi 1/0

2w1d22h: %RPM0-P:CP %IFMGR-5-OSTATE_DN: Changed interface state to down: Gi 4/0

2w1d22h: %RPM0-P:CP %IFMGR-5-INACTIVE: Changed Vlan interface state to

inactive: Vl 1

2w1d22h : FEFD state on Gi 4/0 changed from Bi-directional to Unknown

Dell#debug fefd packets

Dell#2w1d22h : FEFD packet sent via interface Gi 1/0

526

Layer 2

1 2 ... 521 522 523 524 525 526 527 528 529 530 531 ... 985 986

Komentáře k této Příručce

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 526

Komentáře k této Příručce

Související produkty a manuály pro Software Dell Networking S6000