Dell Networking S6000 Uživatelský manuál Strana 935

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 986
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 934
NOTE: You must configure all virtual routers in the VRRP group the same: you must enable
authentication with the same password or authentication is disabled.
To configure simple authentication, use the following command.
Configure a simple text password.
INTERFACE-VRID mode
authentication-type simple [encryption-type] password
Parameters:
encryption-type: 0 indicates unencrypted; 7 indicates encrypted.
password: plain text.
Examples of the authentication-type Command
The bold section shows the encryption type (encrypted) and the password.
Dell(conf-if-gi-1/1-vrid-111)#authentication-type ?
Dell(conf-if-gi-1/1-vrid-111)#authentication-type
simple 7 force10
The following example shows verifying the VRRP authentication configuration using the show conf
command. The bold section shows the encrypted password.
Dell(conf-if-gi-1/1-vrid-111)#show conf
!
vrrp-group 111
authentication-type simple 7 387a7f2df5969da4
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
Dell(conf-if-gi-1/1-vrid-111)#
Disabling Preempt
The preempt command is enabled by default. The command forces the system to change the MASTER
router if another router with a higher priority comes online.
Prevent the BACKUP router with the higher priority from becoming the MASTER router by disabling
preempt.
NOTE: You must configure all virtual routers in the VRRP group the same: you must configure all
with preempt enabled or configure all with preempt disabled.
Because preempt is enabled by default, disable the preempt function with the following command.
Prevent any BACKUP router with a higher priority from becoming the MASTER router.
INTERFACE-VRID mode
no preempt
Examples of Disabling Preempt
Re-enable preempt by entering the preempt command. When you enable preempt, it does not display in
the
show commands, because it is a default setting.
Virtual Router Redundancy Protocol (VRRP)
935
Zobrazit stránku 934
1 2 ... 930 931 932 933 934 935 936 937 938 939 940 ... 985 986

Komentáře k této Příručce

Žádné komentáře