Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 44)

100

101

Accessing the Console Port

To access the console port, follow these steps:

For the console port pinout, refer to Accessing the RJ-45 Console Port with a DB-9 Adapter.

1. Install an RJ-45 copper cable into the console port.Use a rollover (crossover) cable to connect the

S4810 console port to a terminal server.

2. Connect the other end of the cable to the DTE terminal server.

3. Terminal settings on the console port cannot be changed in the software and are set as follows:

• 9600 baud rate

• No parity

• 8 data bits

• 1 stop bit

• No flow control

Pin Assignments

You can connect to the console using a RJ-45 to RJ-45 rollover cable and a RJ-45 to DB-9 female DTE

adapter to a terminal server (for example, a PC).

The pin assignments between the console and a DTE terminal server are as follows:

Table 2. Pin Assignments Between the Console and a DTE Terminal Server

Console Port RJ-45 to RJ-45

Rollover Cable

RJ-45 to RJ-45

Rollover Cable

RJ-45 to DB-9

Adapter

Terminal Server

Device

Signal RJ-45 Pinout RJ-45 Pinout DB-9 Pin Signal

RTS 1 8 8 CTS

NC 2 7 6 DSR

TxD 3 6 2 RxD

GND 4 5 5 GND

GND 5 4 5 GND

RxD 6 3 3 TxD

NC 7 2 4 DTR

CTS 8 1 7 RTS

Default Configuration

A version of Dell Networking OS is pre-loaded onto the chassis; however, the system is not configured

when you power up for the first time (except for the default hostname, which is Dell). You must

configure the system using the CLI.

Configuring a Host Name

The host name appears in the prompt. The default host name is Dell.

• Host names must start with a letter and end with a letter or digit.

Getting Started

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 985 986

Komentáře k této Příručce

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 44

Komentáře k této Příručce

Související produkty a manuály pro Software Dell Networking S6000