Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 334)

100

101

9. Traffic from North-South and South-North nodes are of line rate type.

10. Traffic outage for a planned reboot is less than 30 seconds for 4000 routes of IPv4 and IPv6 traffic

for all of the following traffic directions. These traffic patterns apply only to the S6000 platforms.

• South-North

• North-South

• East-West

• West-East

To the south of ToR switch, 96 servers can be linked. Up to 8 Multiprocotol BGP (MP-BGP) sessions to

the servers are established. You can configure a minimum of 2 MP-BGP sessions and a maximum of 8

MP-BGP sessions.

To the north of the ToR switch, up to 8 leaf nodes are connected. Up to 8 EBGP sessions for IPv4 and

IPv6 for each leaf node are configured. LACP is enabled between the ToR and leaf nodes, and the LACP

long timer is set to the default value. You must configure 96 ports to be 10-Gigabit Ethernet interfaces

and 8 ports as 40-Gigabit Ethernet interfaces. You must configure the switch to operate with an uplink

speed of 40 Gigabit Ethernet per second.

Interoperation of Applications with Fast Boot and System

States

This functionality is supported on the S6000 platform.

The following sections describe the application behavior when fast boot functionality is enabled:

LACP and IPv4 Routing

Prior to the system restart, the system implements the following changes when you perform a fast boot:

The system saves all dynamic ARP entries to a database on the flash drive.

A file is generated to indicate that the system is undergoing a fast boot, which is used after the system

comes up.

After the Dell Networking OS image is loaded and activated, and the appropriate software components

come up, the following additional actions are performed:

• If a database of dynamic ARP entries is present on the flash drive, that information is read and the ARP

entries are restored; the entries are installed on the switch as soon as possible. At the same time, the

entries are changed to an initial (“aged out”) state so that they are refreshed (and flushed if not learnt

again). The database on the flash card is also deleted instantaneously.

• The system ensures that local routes known to BGP are imported into BGP and advertised to peers as

quickly as possible. In this process, any advertisement-interval configuration is not considered (only

during the initial period when the peer comes up).

If you do not configure BGP GR, you must configure the peering with BGP keepalive and hold timers to

be as high as possible (depending on your network deployment and the scaled parameters or sessions) to

enable the connection to be active until the system re-initializes the switch, causing the links to adjacent

devices to go down. If the BGP sessions are disabled before the re-initialization of the switch occurs

334

Flex Hash and Optimized Boot-Up

1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 985 986

Komentáře k této Příručce

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 334

Komentáře k této Příručce

Související produkty a manuály pro Software Dell Networking S6000