Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 810)

To configure and enable the interfaces for Layer 2, use the following command.

1. If the interface has been assigned an IP address, remove it.

INTERFACE mode

no ip address

2. Place the interface in Layer 2 mode.

3. Enable the interface.

INTERFACE mode

Example of the show config Command

To verify that an interface is in Layer 2 mode and enabled, use the show config command from

INTERFACE mode.

Dell(conf-if-gi-1/1)#show config

interface GigabitEthernet 1/1

no ip address

Dell(conf-if-gi-1/1)#

Enabling Spanning Tree Protocol Globally

Enable the spanning tree protocol globally; it is not enabled by default.

When you enable STP, all physical, VLAN, and port-channel interfaces that are enabled and in Layer 2

mode are automatically part of the Spanning Tree topology.

• Only one path from any bridge to any other bridge participating in STP is enabled.

• Bridges block a redundant path by disabling one of the link ports.

Spanning Tree Protocol (STP)

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 810