Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 396)

100

101

– ip-selection [dest-ip | source-ip] — Distribute IP traffic based on the IP destination or

source address.

– mac [dest-mac | source-dest-mac | source-mac] — Distribute IPV4 traffic based on the

destination or source MAC address, or both, along with the VLAN, Ethertype, source module ID

and source port ID.

– tcp-udp enable — Distribute traffic based on the TCP/UDP source and destination ports.

– ingress-port — Option to Source Port Id for ECMP/ LAG hashing.

– ipv6-selection— Set the IPV6 key fields to use in hash computation.

– tunnel— Set the tunnel key fields to use in hash computation.

Changing the Hash Algorithm

The load-balance command selects the hash criteria applied to port channels.

If you do not obtain even distribution with the load-balance command, you can use the hash-

algorithm

command to select the hash scheme for LAG, ECMP and NH-ECMP. You can rotate or shift

the 12–bit Lag Hash until the desired hash is achieved.

The nh-ecmp option allows you to change the hash value for recursive ECMP routes independently of

non-recursive ECMP routes. This option provides for better traffic distribution over available equal cost

links that involve a recursive next hop lookup.

To change to another algorithm, use the second command.

• Change the default (0) to another algorithm and apply it to ECMP, LAG hashing, or a particular line

card.

CONFIGURATION mode

hash-algorithm | [ecmp{crc16|crc16cc|crc32LSB|crc32MSB|crc-upper|dest-ip |lsb

|xor1| xor2| xor4| xor8| xor16}|lag{crc16|crc16cc|crc32LSB|crc32MSB|xor1|

xor2|xor4|xor8|xor16}| seed ]

For more information about algorithm choices, refer to the command details in the IP Routing

chapter of the Dell Networking OS Command Reference Guide.

• Change the Hash algorithm seed value to get better hash value

Hash seed is used to compute the hash value. By default hash seed is chassis MAC 32 bits. we can also

change the hash seed by the following command.

CONFIGURATION mode

hash-algorithm seed {seed value}

• Change to another algorithm.

CONFIGURATION mode

hash-algorithm [ecmp{crc16|crc16cc|crc32LSB|crc32MSB|crc-upper|dest-ip|lsb|

xor1|xor2|xor4|xor8|xor16}]

Example of the hash-algorithm Command

Dell(conf)#hash-algorithm ecmp xor 26 lag crc 26 nh-ecmp checksum 26

Dell(conf)#

396

Interfaces

1 2 ... 391 392 393 394 395 396 397 398 399 400 401 ... 985 986

Komentáře k této Příručce

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 396

Komentáře k této Příručce

Související produkty a manuály pro Software Dell Networking S6000